Hello folks, been following here for a couple of years. I’m about to finally start on my 21 yr project in the making. It’s a 68 Chevelle that I’ve had since the early 90's. What I thought was a solid car was really not after having it blasted. I am going to end up re-skinning the car completely less the hood & deck lid. Hope you folk enjoy the pics. I went to AMD here in Georgia & saw they ware house & let me tell you it’s a site to see. Please feel free to chime in.
Thanks Luke. The car was little worse off than expected ,but the sub structure is fine. I'm have the work done at "Zamot Rodz" here in Georgia. Here are some updates pics. Enjoy
Good to a see another GA guy on the boards. I'm down here in south GA if you need help with project palnning, parts, work done, etc . Don't hesitate to ask. Dealer for 100's of lines, and always like shooting the **** about projects to help you out.
__________________
Chad Fletcher
Fletcher's Customs and Speed
229-221-4690 [email protected]
Not a 100% sure yet. I would love to run a modern drive line, but for now I have a small block with an edelbrock topend backed with a TCI tb350, 2500 stall. Going to run that drive line until I can afford a diff,. set up. Can anyone sugest someone that I can do a rendering for my car? I haven't seen any 68 rendering yet. Thanks in advance
Nice pics,the guys from amd do great work,had them do my 69z camaro when they were at goodmark,have to keep up with this one as i am doing a 69 chevelle now. keep in touch