Driveshaft .. a judgment call.

[Spiffav8]

I see why you’re confused. The link provided says it’s a 1350 but also that it’s a 29 spline with a blank spot that makes it a 30. Wish I had an answer for you.

[bdahlg68]

Originally Posted by XLexusTech

I am not shy about spending smart money and would have no issue dropping 2k on a driveshaft.. . If you have roughly 8-12 weeks for a DSS or QA1 shaft.. go for it if you think more $$ equates to higher quality... I suspect none of these vendors are making these tubes or ends.. they are assembling from the same sources.. . .. after talking to mike I am confident in his knowledge and quality.
He build for some race car guys.. and would be out of business fast if the quality was sub par relative to higher cost alternatives.. Really feels to me a brand name marketing Difference to me.. .

QA1 does make their own tubes (as in mandrels for winding and cure ovens).

[XLexusTech]

Originally Posted by bdahlg68

QA1 does make their own tubes (as in mandrels for winding and cure ovens).

ironically the three month wait was through te off QA1...

the irony of that decision was made in December