C6 Weld-On Flange Ends

[mitch_04]

I sure hope these are still around when I get to the point of needing them!

[MillerBuilt]

Originally Posted by Rick D

Very nice Jay, glad to see you still have the crestive juices flowing!!

Thanks Rick!

[MillerBuilt]

Originally Posted by mitch_04

I sure hope these are still around when I get to the point of needing them!

There is no time like the present! Pay the mortgage with what's left!

[Build-It-Break-it]

Do you have pictures of everything installed on the rear end? I like the set up. If I didn't have me rear end already done this might of been the route I took.

[MillerBuilt]

Originally Posted by Build-It-Break-it

Do you have pictures of everything installed on the rear end? I like the set up. If I didn't have me rear end already done this might of been the route I took.

Her is one in the alignment fixture....


[IMG][/IMG]

[IMG][/IMG]

[IMG][/IMG]

[Vince@Meanstreets]

Who's lateral dynamics rear housing? Yours?

[MillerBuilt]

Originally Posted by Vince@MSperfab

Who's lateral dynamics rear housing? Yours?

This was a customers. I have/will be running a Strange Housing. Really like them.

[kevmurray]

Very nice pieces! I was planning to do this myself recently, though I would have to do my own machining. This is a nice option.

[no go nova]

Wish this was around before I bought my wilwood rear breaks. Love your bringing good ideas to life.

[takid455]

I am guessing axle will have a threaded portion on the end such to affix a nut? Wont this 'pull' on the 'C' clips and cause unwanted wear? 9" applications wont have this issue what will prevent the axle from sliding out on a 9"

Just not picturing the axle setup at the moment.