Dse lower control arms need 9/16 bolt.
Instruction tell to use a unibit but I wasnt able to drill the hole on the rear mount.
I use a 9/16 drill bit. Shank side was 1/2. I welded it on a 1/2 rod and it worked real good.
__________________
The French Frog
The Following User Says Thank You to streetbird For This Useful Post:
I just started to fit the front end but all panel was off.
1'' gap on the nose in the beginning but it turned ok.
Still some work to do on the fenders.
So close to look like a car for the first time
__________________
The French Frog
The Following 2 Users Say Thank You to streetbird For This Useful Post: