Fantanstic Wayne .... does that mean the car will be done soon !!??
Steve
I'm hoping so!
It goes in 3 weeks to put coil overs on the sub frame, the springs on it are too low. So I'll bit the bullet put Chicane kit with RideTech coil overs.
I'm hoping so!
It goes in 3 weeks to put coil overs on the sub frame, the springs on it are too low. So I'll bite the bullet put Chicane kit with RideTech coil overs.
Thanks Guys!
OK seriously, when Wayne's car is finally complete I think EVERYONE here that has known Wayne this long needs to crack open a bottle of Champagne or simply toast Wayne for his 8000+ posts, his 444 thanks and his absolute pursuance in getting this car done !!
Wayne, wow ... well done
Cheers
Steve
__________________
'Build it RIGHT the 2nd time'
69' SS X11 PRO-TOURING - SOLD
73' FJ40 LS - SOLD
1966 FJ40 R2.8 -SOLD
911 Hotrod - SOLD
2002 Gated 360
Next up - "Killer Piggy"
The Following User Says Thank You to Sheck44 For This Useful Post:
I just got back from taking the car to get Speed tech Chicane coil over brackets installed, getting the exhaust installed with V bands and tigged, and the frame connector brackets welded to the sub frame.
I just got back from taking the car to get Speed tech Chicane coil over brackets installed, getting the exhaust installed with V bands and tigged, and the frame connector brackets welded to the sub frame.
Since I got my Michelin Tires 345-30-19 I've been wanting to test fit. Mike at MCC built the rear and said it would be tight, Well he did an awesome job they fit with plenty of room. I worried they might be trouble, but today the car went to the guy who's doing the Chicane kit. He's also doing the exhaust so he needed the tire to make sure the tail pipe would clear. When I got to his place I asked him to try it while I was there, to either let me know I was all set or if I needed an antacid for the gut ache I would have if it was too tight. What a relief the ant acid stays in the cabinet!
Here are some pictures of them in the car.
I could fit my hand between the tire and the fender as far as my knuckles. He's also going to weld the DSE frame connector brackets to the sub, they'll bolt to the connector.