I just received my kick panels. Man, these things look awesome!!! I'm going to have to drill 3 NEW mounting holes, trim the E-Brake bracket, and move the floor dimmer switch for them to install. I was hoping the 3 mounting holes (on new panels) would line up with existing mounting points, that's a no go for my 69. Also its a good idea to adjust the E-Brake pedal (tighten up) so as to limit travel of the pedal, otherwise the pedal will hit the kick panel.
__________________
69 Camaro Convertible (LS3/TKO in the works)
I just received my kick panels. Man, these things look awesome!!! I'm going to have to drill 3 NEW mounting holes, trim the E-Brake bracket, and move the floor dimmer switch for them to install. I was hoping the 3 mounting holes (on new panels) would line up with existing mounting points, that's a no go for my 69. Also its a good idea to adjust the E-Brake pedal (tighten up) so as to limit travel of the pedal, otherwise the pedal will hit the kick panel.
Thanks a ton for the purchase and the feed back, it seems that most of these installs do vary slightly from one to another with the e brake and dimmer switch. We have had a few in the shop that were easy peasy and a few where the E brake dose get just a a slight trim. Thanks again!
A quick trim to the e brake and the kick will slide right in, as far as tweeters, if you can get them up higher in a pillar or door panel that would be best, if not, run a coax component in the kick.. Here are a few pics of the e brake.. We can pop a hole under the 6.5 for a tweeter there is plenty of room.. Thanks for the feed back guys
Looking forward to receiving my order. I think it's the best looking setup around. Hope mods are kept to a minimum. It is tight under the dash as it is, and I have already had issues with the emergency brake light switch and the AWW wire harness fuse block.
Thanks.
Ive been on your site, but i cant seem to find where the kickpanels are sold separately. Are thry? I am not interested in the package tray or sub enclosure.