...

Go Back   Lateral-g Forums > Technical Discussions > LSX Conversions
User Name
Password



Reply
 
Thread Tools Display Modes
  #1  
Old 02-12-2019, 06:23 PM
jasonz28camaro jasonz28camaro is offline
Member
 
Join Date: Aug 2017
Posts: 94
Thanks: 2
Thanked 6 Times in 5 Posts
Default Used exhaust for a 1st Gen Camaro

Not sure it this is the right section for this question?

I'm looking for opinions on using used exhaust for my 68 camaro rather than buying a new set to save some money. I can weld and cut as needed. I feel like a new system is a little pricey and I will not be using all the pieces as the over axle will not fit without some modification with my Ridetech rear. Plus I see a lot of the systems are 400 series SS, I'd rather not use this.

I was looking into a used aftermarket 3" corvette x-pipe to stick under there, not sure if it would interfere with the tunnel or driveshaft. Or I was thinking of this Hellcat mid section in the photo below, comes with two mid sections, all 4 pipes and is 304SS. I'd like to make this an x-pipe setup and there looks to be enough metal there to make it work for a faction of the cost of a new setup. Then add mufflers and dump it, possibly go under the rear later down the road if I don't like the drone.

Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 11:50 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright Lateral-g.net