More rust repair

http://img.photobucket.com/albums/v3...ustang/453.jpg

http://img.photobucket.com/albums/v3...ustang/454.jpg

http://img.photobucket.com/albums/v3...ustang/455.jpg

Filling the factory lead joint

http://img.photobucket.com/albums/v3...ustang/457.jpg

http://img.photobucket.com/albums/v3...ustang/458.jpg

The last patch needed on the roof

http://img.photobucket.com/albums/v3...ustang/450.jpg

Brian cut out the rust than epoxy primed

http://img.photobucket.com/albums/v3...ustang/463.jpg

Next he made a few patches

http://img.photobucket.com/albums/v3...ustang/464.jpg

Brian at work grinding the welds

http://img.photobucket.com/albums/v3...ustang/465.jpg

http://img.photobucket.com/albums/v3...ustang/466.jpg

Finished grinding

http://img.photobucket.com/albums/v3...ustang/467.jpg

Great work!

Nice work.

Awesome.

I finished most of the body work and now ready for epoxy primer

http://img.photobucket.com/albums/v3...ustang/468.jpg

http://img.photobucket.com/albums/v3...ustang/469.jpg

I sprayed 2 coats of SPI black epoxy

http://img.photobucket.com/albums/v3...ustang/470.jpg

http://img.photobucket.com/albums/v3...ustang/471.jpg

Nice progress it came out nice.

I want one of these. Must add to the bucket list

This project has been on hold for awhile but it is time to finish it so we got it out of storage and into the fab shop. The first thing Brian did was line up the deck lid.

http://img.photobucket.com/albums/v3...psrdibee8k.jpg

He had to do a little cutting and welding on it and I did the bodywork and sprayed two coats of SPI epoxy.

http://img.photobucket.com/albums/v3...psb8id7xcz.jpg

Block sanded and sprayed SPI Turbo primer.

http://img.photobucket.com/albums/v3...pszzmnec8b.jpg

The customer wanted vents in the hood and I found these. This is not his car.

http://img.photobucket.com/albums/v3...psbewwn8cn.jpg

After Brian did a lot of measuring he found out they would fit without modifying the brace.

http://img.photobucket.com/albums/v3...psfnlfek9i.jpg

He just had to trim a little of the flat part of the brace

http://img.photobucket.com/albums/v3...pssecz7dj0.jpg


http://img.photobucket.com/albums/v3...ps7dvqy2f9.jpg

Brian used 3m8115 panel bond.

http://img.photobucket.com/albums/v3...pscloaij2c.jpg

http://img.photobucket.com/albums/v3...psdgpr56sf.jpg

http://img.photobucket.com/albums/v3...psk28hyies.jpg

http://img.photobucket.com/albums/v3...psglnfozkv.jpg