Lateral-g Forums - Heim joint clutch rods

Page 2 of 2

Show 40 post(s) from this thread on one page

Lateral-g Forums (https://www.lateral-g.net/forums/index.php)

- Transmission and Rear End (https://www.lateral-g.net/forums/forumdisplay.php?f=39)

- - Heim joint clutch rods (https://www.lateral-g.net/forums/showthread.php?t=31144)

ccracin

03-18-2011 09:23 AM

Quote:

Originally Posted by Sieg (Post 338752)

I was hoping to source some smaller bungs similar to these:
http://www.g-forcesuspension.com/ima...img-110_01.jpg

That would make the project pretty simple.

Thanks for the assistance. :thumbsup:

Go here: http://www.ubmachine.com/tierodtubes.html

I think these will make it even easier. If they have the right size for you, obviously. Hope it helps. :cheers:

Sieg	03-18-2011 10:49 AM

Quote:

Originally Posted by ccracin (Post 338917)

Go here: http://www.ubmachine.com/tierodtubes.html

I think these will make it even easier. If they have the right size for you, obviously. Hope it helps. :cheers:

Thanks Chad! I think they're a little on the big side but I like that company. Thanks for another resource. :cheers:

BonzoHansen

03-18-2011 12:07 PM

Quote:

Originally Posted by Sieg (Post 338674)

Didn't see any on their website. I saw them somewhere and can't find the link, heim jointed adjustable. Though it was from one of Lat G's sponsors. :(

Edit - Found them:

http://cmc.speeddirect.com/itemdesc....%2D125&eq=&Tp=

I saw that Mary Pozzi made her own, I'm tempted, but for $90 these appear decent.

I have this, replaces the stock rods. I thought it made a nice difference on clutch pedal feel. I'm sure if you have the parts & ability there is not much to it.

David Pozzi

03-19-2011 10:06 AM

Here's my page in doing a first gen clutch rod.
http://pozziracing.com/first_gen_clutch_linkage.htm

Denvervet

03-19-2011 09:29 PM

speedway motors sells the rods and joints....just got to figure out what sizes you need.

Sieg	03-20-2011 08:03 AM

Quote:

Originally Posted by Denvervet (Post 339175)

speedway motors sells the rods and joints....just got to figure out what sizes you need.

Thanks, big selection, doesn't appear they have 1/2" OD tube, closest I found was 3/8" thread 3/4" OD tubing. I'm guessing that's a little too big.

Did find some 3/16" thread 5/16" OD throttle linkage tubing though! :thumbsup:

All times are GMT -7. The time now is 12:22 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page