Originally Posted by F'in mine (Post 706638)

I ended up adding a little extra insulation around some critical areas where exhaust heat from headers, intermediate pipes and mufflers are routed as well as the back seat divider.
https://www.thermotec.com/products/s...hermo-guard-fr
I found that the extra barrier helped fill in the carpet better.
To punch around bolt holes......take a piece of thin diameter pipe 3/4"-1", grind a bevel around the tubing then hammer at areas that you need to fasten stuff to, makes a nice clean open area.

Originally Posted by paulk68 (Post 706652)

that looks great! will probably do the same. did you use the spray adhesive to install it?

Originally Posted by F'in mine (Post 706665)

No I just used some thin 2 way tape to hold it in place. Didn't want to fight with it if I ever have to remove it.

Originally Posted by jarhead (Post 706864)

Paul, is it hard to put it inside the doors? I was under the impression this stuff sticks and there is no chance to peel or move it when it does.
Thanks