thanks for the quick response

Back on the market................. this is a crazy good deal on this stuff. The block was this much all by itself.

It's a Gen VI block that has been line honed and decked. It was brand new when I bought it. It's .030 over with a 4.280 bore. It also comes with the timing cover and a remote oil filter adapter.
The crank is a scat cast external balance standard with 4.25 stroke. Rated for 700hp. I also have a professional products balancer and centerforce billet sfi flywheel with low miles.
I have a set of I beam rods(6.385) with ARP cap screws.
The cam is a crane billet hydraulic roller with press on cast gear.(For longevity) .632 lift I/E 244/256 at .050 on a 114 lsa. Made 593hp at 6k and 587 at 3700.
Also have a moroso 6 qt oil pan that fits a Camaro and multiple other cars.
It's all in good shape, the cylinders may need a bore.
I'd let it all go for $1100 firm if you pick it up.

That's an amazing deal. I wish I lived closer to you.

I just went through this with the last buyer. He lived in Northern Cal and shipping was only $280 if I drop it off at Yellow freight here in town and you pick it up. If you can't pick it up then it's like $420 to your door. I am also going over to Hesperia CA in February. You could meet me there and save on shipping.

Hey whats in Hesperia... ?:_paranoid I didn't think anyone knew where Hesperia is.:)

My engine buidler, Pettis Performance.:thumbsup:

LOL... they sure are. Half a block away!

GREAT DEAL!:thumbsup:
Bump for Todd.

Todd I can't believe you haven't sold this stuff yet. If I wasn't stuck on building a 540 I would buy it from you in a heart beat. However I may know someone that may be looking for what you have I will let you know in the morning.

Thanks.....it was pending for a week. If I had room I'd keep it. Lot's of interest, I'm sure it will be down the road soon. Let me know on your buddy.