GMR BILLET Front C5/6 Hubs
 

Up for sale is my personal set of Billet Front C5/6 Hubs. My project has changed course and these are no longer needed.

These are a direct replacement for the stock C5/6 hub units. They retail at over $2020.00+ tax as pictured with Wilwood Rotor Adaptors & Socket Tool (to tighten spindle nut).
This pair can be yours for $1300.00 obo (Mesa,AZ)

***I can accommodate different Caliper/Rotor combinations.
***This setup will add just under +3/16" per side to track width.

Sunday Bump!

Sunday ttt!

To The Top...

Still available?

Actually have two sets available...

More Pics!
 

Below are with WILWOOD Rotor Adapters....
[IMG]http://i35.photobucket.com/albums/d1...ps4812bc04.jpg[/IMG]

Below are with BAER Rotor Adapters....
[IMG]http://i35.photobucket.com/albums/d1...ps1ca9c9d2.jpg[/IMG]

C5/6 Billet Hubs
 

I also have available 2 sets that where used for mock-up ONLY. They are nearly flawless with the exception of a few VERY minor scratches that will not show once mounted. These sets I will sell at a highly discounted rate of $900 per set!!!!! :hairpullout:

I think I already know the answer but would they work with stock Z06 rotors
Ryan Austin

Although not designed with this rotor application in mind, YES it will work. You would slide the one piece rotor over/onto the Billet Hub just like the OEM, then you would be required to put spacers between caliper mounting lug and the C5/6 Upright caliper mounting point (basically spacing the caliper out over the rotor that would be sitting "outward" approx. 3/16"...... these spacers can be purchased at most any ACE hardware/etc. in the form of a extra thick washer. I use the same type setup when mounting Brake Man Calipers to these hubs....

Still available, this is a great deal!

Bump!

Bump!