LS7 dry sump tank
 

Other than the stock and Peterson LS7 tank I'm thinking of building my own tank to better fit my Camaro. I remember seeing a tank IIMuch built and maybe Ironworks? That fit the passenger bulkhead. Is there anything special about the insides of the tanks or measurements of the baffles or even angles of the return line? I want to keep it right around 11q or so and there is enough room for it.

Do some digging on www.aviaid.com they have some drawing,baffles,inserts, diagrams etc all pertaining to the ls7 oil systems . Could also go the route I probably will and just convert it to ls3 wet sump and not have to worry about cost, oil lines everywhere and possibly oil cavitation. Plus you'll gain a few hp with a wet sump

That link has a ton of good information on it, thank you. I'm doing the dry sump as I plan on tracking the car and I tend to push pretty hard on things.

Ten fir ..(yes I did that on purpose) well good luck hope you get or find what you need

Just FYI, this is the opposite of what is true about dry sump vs. wet sump.

Have you checked into any NASCAR or SCCA racing publicationshttp://s1064.photobucket.com

Is this what you are thinking? This is on JA 2.0. Don't know how they did the inside.

I haven't seen that one before. I was thinking IIMuch and Ironworks were squared off and fit in place following the stock body lines.

[QUOTE=CamaroAJ;634660]I haven't seen that one before. I was thinking IIMuch and Ironworks were squared off and fit in place following the stock body lines.[/QUOTE

I bet that unit has a separation baffle from the round area to the box on the side. I have never heard anything good about square dry sump tanks.

The one we put in the cowl of my Camaro was round.

http://i616.photobucket.com/albums/t...ust2009156.jpg

actually on this motor with a stock set-up yes it is quite true ...one of the major magazines tested a ls7 and then swapped it over ...actually it could have even been horsepower tv ...regardless it was somewhere in the 7-11 hp range


correction 3-4 hp thru the rpm range heres the link http://www.hotrod.com/how-to/engine/...mp-conversion/

Thats clean and how I was thinking of doing mine. What did you guys do with the inner cowl area where the wiper transmission goes to prevent water puddling if any were to get in there?

Shaved the cowl, who needs wiper in California?

At least hook up the driver side so you can drive it if the weather goes bad.And it does rain ,and rain hard.It even snows down there. I know because I was stationed down there for five years while in the Marine Corps.http://s1064.photobucket.com

Did you just say rain hard? Come on....


Snow is in the mountains.

We call that sprinkles everywhere else in the country lol.

No it snowed in downtown L.A. And being from the Pacific NW it was interesting how the locals reacted.http://s1064.photobucket.com

so a dusting of snow in la and the once in a blue moon rain....

And I would not drive my Camaro that one day every ten years.