Art Morrison 4 tri bar
 

How does this kit compare to the alston tr bar and DSE 4 link?

I havent heard alot of info on them.

thanks
Dave

Since nobody bit on this, I'll add my two cents.

I'm not sure if it really does compare with Alston's or DSE's setups. I say that because their designs fit the stock frame rails, while ours is an entire replacement rear clip for those willing to remove the stock trunk. Perhaps this will change in the future. Anyway, they are very different products.

It is a proven design, as seen in Art's '55 Chev and '60 Vette, as well as others.

Well this is were i am at.

i have a 67 camaro that needs a complete floor and trunk. I am putting DSE wheel tubs. So i purchased a set of 21st century frame rails knowing that i will most likely have to cut out a section of the trunk floor. I have been debating on a fuel cell instead of a stock fuel tank.

So i guess my point is, since i am moving the frame rails, i will have to modify any kit that i go with. But the A.M. suspension seems to be less modification to fit in. My question was based on performance.

That's tough to compare. I'm not sure if you'll find any hard data to make the decision easy.