Lateral-g Forums - Using aftermarket Hydraulic Thowout bearing

Lateral-g Forums (https://www.lateral-g.net/forums/index.php)

- Transmission and Rear End (https://www.lateral-g.net/forums/forumdisplay.php?f=39)

- - Using aftermarket Hydraulic Thowout bearing (https://www.lateral-g.net/forums/showthread.php?t=18383)

JamesJ

01-08-2009 02:06 PM

Using aftermarket Hydraulic Thowout bearing

I remember reading that someone made an adapter or maybe a new hose to be used when using the factory hydraulic clutch master with an aftermarket hydraulic throwout bearing such as a McLeod unit. I think that it replaced the quick connect with and AN fitting. Does anyone remember this? Or know where to get something that will work?

1 Dwn Cam

01-14-2009 04:54 PM

What is your setup? LS motor and LS T-56?

Tiger

01-15-2009 01:31 PM

I was planning to use a T5 bellhousing with the attached slave so I cut the quick connect and silver welded an AN to it.
never got around to use it but its a way of doing it.

JamesJ

01-16-2009 01:47 PM

Quote:

Originally Posted by 1 Dwn Cam (Post 189007)

What is your setup? LS motor and LS T-56?

LT-T56 with a SBC

Quote:

Originally Posted by Tiger (Post 189180)

I was planning to use a T5 bellhousing with the attached slave so I cut the quick connect and silver welded an AN to it.
never got around to use it but its a way of doing it.

Thats what I will do if I cant find this... I think it may have been a new hose that has has the AN fitting already installed.

All times are GMT -7. The time now is 07:19 AM.