Lateral-g Forums - hydraulic clutch lines

Lateral-g Forums (https://www.lateral-g.net/forums/index.php)

- Transmission and Rear End (https://www.lateral-g.net/forums/forumdisplay.php?f=39)

- - hydraulic clutch lines (https://www.lateral-g.net/forums/showthread.php?t=34269)

usa-69z

11-10-2011 10:21 PM

hydraulic clutch lines

Was thinkin has anyone made there own clutch to master lines using the teflon braid ?
I did make all my fuel lines using the telfon braid for my injection and wondered is there any difference in pressures for clutch rather than fuel ? and will the anodized ends be ok with these type of fluids etc?
As my car is a RHD 69 camaro i need a longer piece from master to the hydraulic throwout bearing.

thanx , Gav:)

MarkM66

11-11-2011 11:45 AM

I've used braided brake line/hose to go from my master cylinder to my slave.

My local street rod shop has pre-made lengths.

FrankZ

11-11-2011 11:33 PM

Making your own lines is fairly simple..........but I would use steel ends not the aluminum.

usa-69z

11-12-2011 02:04 AM

Quote:

Originally Posted by FrankZ (Post 378248)

Making your own lines is fairly simple..........but I would use steel ends not the aluminum.

ok , thanx Frank

GregWeld

11-12-2011 05:58 PM

Quote:

Originally Posted by usa-69z (Post 378276)

ok , thanx Frank

Nothing wrong with using Braided SS BRAKE lines -- you can buy them in various lengths.... in either -3 or -4

All times are GMT -5. The time now is 09:10 AM.