Help help, installed kill switch
 

My battery is in the trunk, had american auto wire install, their 10 guage wire went from my one wire alternator to the starter. I decided to install a big switch flaming river kill switch in the trunk, so what I did was disconnect and remove the 10 gage wire from the alternator to the starter and installed a 4 guage wire from the alternator straight back to the kill switch in the trunk to the battery side on the other side of the kill switch I connected the 0 gage wire from the starter. Here's my problem, before I began the switch the car started and ran perfect and now that I'm finished the car has a hard time starting, acts like it's flooded, runs really rough for a couple of seconds and dies. Any ideas? Here's a diagram I used for running the alternator wire to the kill switch in the trunk. Thanks

http://img585.imageshack.us/img585/7913/8565.jpg

If you only messed with the positive cable and not any negative cables the issue is either your new kill switch or the alternator is not working. It sounds your not getting enough voltage to keep the ecu happy. check the output voltage of the alternator, and if its good, there has to be an internal issue with the kill switch.

Lenie, did you interrupt any grounding means during this swap? Does the starter turn slowly?

Upon thinking about this a little, are you sure that you put the cutoff switch on the correct wire? I've always installed my cutoff switches on the ground circuit, instead of the positive battery wire. It removes all load from the switch.
I'm not saying it won't work the way you have it wired, I've just never done it that way.

Totally agree with using only the ground for killing stuff -- never the positive side!

Dumb me didn't pay close enough attention to your diagram on how you hooked it up. As others have stated, I would move the kill switch to the negative side, but if there is still an internal issue with the switch, it will still cause issues. I did go to Flaming Rivers site and they show the switches to be load rated, but always safer to switch grounds.

Thanks everyone, I did disconnect the negative and positive while installing, in the morning I'll switch it over to ground and see what happens. Appreciate the quick responses, I am an electrical dummy!

Take the switch out and connect the 2 wires.... If the issue is gone, it's the switch itself, not the location in the circuit

Bingo, thanks Ned.