First Gen ECU mounting
 

Where are most people putting them? I am running the Holley HP EFI setup and I think I have enough harness to make it to under the passenger seat. Anyone else mounted an ECU there?

In coupple last builds I've put them inside the dash, just over the glovebox.

made a plate out of aluminum and mounted my holley ecu tucked up under fender behind core support in my 69 camaro

I put my ecu against the firewall on the driver side, inside the fender.


Z

mine is installed under the 2013 5th Gen Camaro console

it is a LS2 (gen III 24x, "411" pcm)

Jeff

Awesome job Jeff. Is it forward of the guage pod? Also, are those 5th gen seats? (I posted below trying to get some info on that).

The pcm is actually mounted ( using a stock GM pcm mounting bracket) under the front of console / gauge pod

The seats started as new Hunsaker Motorsports that I had recovered / reworked by a buddy that owns a upholstry shop here that I also built a LS2 engine for it trade for both front and rear seat reupohlstry done

Thanks Jeff

mounted mine above and behind the glove box.

Are you running AC

Mine is a 02 Camaro ECU mounted behind the glove box door. Has AC too.