Lateral-g Forums - mounting Poly mount to T-56 hardware

Lateral-g Forums (https://www.lateral-g.net/forums/index.php)

- Transmission and Rear End (https://www.lateral-g.net/forums/forumdisplay.php?f=39)

- - mounting Poly mount to T-56 hardware (https://www.lateral-g.net/forums/showthread.php?t=54750)

paulk68

04-03-2017 08:43 AM

mounting Poly mount to T-56 hardware

can anyone tell me what hardware and sizes are needed to mount my poly trans mount to my t-56 magnum? my directions say use original hardware but i dont have any of that. Thanks

DEIGuy38

04-03-2017 09:39 PM

Found this on LS1 Tech, I used the stock hardware and this seem right. I believe Home Depot or Lowes will have these in the parts bins.

M10x1.50x40mm long. I ordered mine from Mcmaster Carr.

paulk68

04-04-2017 05:35 AM

Quote:

Originally Posted by DEIGuy38 (Post 656849)

Found this on LS1 Tech, I used the stock hardware and this seem right. I believe Home Depot or Lowes will have these in the parts bins.

M10x1.50x40mm long. I ordered mine from Mcmaster Carr.

Thank you Very much!! did you happen to put a washer on there also?

DEIGuy38

04-04-2017 10:14 PM

Quote:

Originally Posted by paulk68 (Post 656856)

Thank you Very much!! did you happen to put a washer on there also?

Yes, i used flat washers on mount to transmission and lock washers at cross member to mount. See the attached from energy suspension
https://www.summitracing.com/parts/e...FQRsfgodfFoN8w

All times are GMT -7. The time now is 09:22 AM.