Speedo cut out
I cut out to about 3" and then used a dremel tool to slowly match fit the gauge exactly to the hole (I wanted it to be really snug). I also made a metal bracket to hold both sides together since I was taking out so much of the middle section.
Rear shot:
Mockup with gauges:
Completed Front (polished the stock lenses):
It is hard to tell with the pictures but the Fuel gauge is held at the same angle as the Speedo and Tach.
Rear:
The Carrier is pretty beat up, and I'll address that when I redo the interior as another project (right now want to get the car running).