04-20-2009, 09:06 AM
|
 |
Senior Member
|
|
Join Date: Dec 2007
Location: Los Angeles, CA
Posts: 572
Thanks: 0
Thanked 0 Times in 0 Posts
|
|
6. Next find the welds on the inside of the trunk that hold the deck lid braces to the inner tubs:
One thing that wasn't clear is, you need to resuse the deck lid braces. Make sure you are easy on them or you are going to need to fabricate new ones (DSE doesn't give you templates for this).
7. Now drill out the welds. For the ones holding to the inner tubs it is probably easier from the outside to do but inside might be easier to make sure you can resuse the braces.
I drilled them out from inside where I could then finished by drilling outside:[
Drill out the rear seat braces as well where it is held in place inside:
|