Quote:
Originally Posted by Motorcitydak
Who makes control arms like that? I just looked at the AFCO site and was going to get em thru there. Is there somewhere better?
Also, the AFCO ones have a 3/16 flange. Not 3/8 like I thought for some reason. I still could use 2 1/4 plates on that and the 3/16 in the middle giving the ball joint 11/16 of steel to ride in
|
Just a couple examples.
http://www.howeracing.com/p-7564-cro...pe-4-bolt.aspx
http://www.detroitspeed.com/1967-196...30101-uca.html
I'm sure there are others out there.
(Actually I just went back and looked at AFCOs arm. They are a better design than they used to be. I haven't dealt with theirs in about 10 years. Those shouldn't need a lot of reinforcing either...)