[Cris@JCG]

Here is another 68 Camaro we are working on here at the shop.. It has been a drag car all its life & now are working on putting back on the street.. When the car was stripped down to bare metal we found that it had lots of rust covered with bondo & card board was used as a backing to hold it in place.. Point of no return.. Owner said fix it & while you are @ it give it some custom touches.. Replacement floors were required with trunk & firewall..
Upgrade list: Scott Mock Sub-frame with C6 suspension, Rear suspension ??, LS2 with T56, Z06 Corvette wheels, & a few JCG custom pcs...






One of main body men who happens to be good @ replacement sheet metal, front sheet metal squaring, & gaping all opening.. wanted to be given the opportunity to do some custom fabrication work.. so since we have so much of it going on right now here @ the shop.. I said.. Go for it!! He wanted a bead roller.. We bought one.. & here are the results so far.. Not bad for his first time on the bead roller!