Quote:
Originally Posted by redfire69
Mario, looks good! These aftermarket panels will fight us all the way. How did you fix the drooping fender?
|
Ron I had to take about 7/16 of an inch out of the corner of the core support . That was the hieght difference from side to side , It made it better but still wasn't where it needed to be . So after about the 20th time taking it on and off the light bulb went off, hey dummy install the extensions and the lower valance!! It pushed it up the little extra It needed . Its just a tiny bit off now but Troy has to cut and slice the area any way for all the header and hood gaps. Then it will be perfect... I work with 3mm cars all day you can't cheat these cars. I get caught up doing the same with this car only thing is close enough was good enough for these cars back then and if it was't good shim it till it was!
Quote:
Originally Posted by syborg tt
AWESOME to see it outside !!!!
|
See you Saturday!!
Quote:
Originally Posted by 67ragtp
Looking good Mario  looks like you could fit a steam roller back there, is that a mock up rear or the real deal? What width flange to flange, I know you got Mikes big bigger biggest inner wheel houses. Im jones'n to see that beast from the back with the fatty's on it.
Rich |
Rich thats the rear end thats staying in the car 45.5 flange to flange..