Quote:
Originally Posted by Flash68
Now that is hilarious right there.  (Sorry Doug  ) |
I am laughing too, what else can you do? I just wonder what part of my body, I'm going to f-up next
---
Porting work so far;
Intake is pretty much done, unless I change the shape of the ports on the head.
The last thing, I am going to do is hit the ports with a coarse file, to texture them a little.
Heads;
I started with an exhaust port, because it's smaller, and a little more forgiving, if I F-it up. I have a pretty good understanding of aerodynamics and hydrodynamics, so used that in shaping the exhaust port, and bowl.
I took into consideration, the shape of the header opening, and raised the port slightly. Next I ovaled the port slightly, again to match the header port, since they are a little taller than the heads.
The bowl is quite a bit deeper on the exit side of the port.
(Head is upside down, in pic below) I didn't do much with the short radius, other than a slight polish. I did turn down the port exit, into the header, as the header pipes all turn down
Once I'm done, the exhaust will get a nice polish, then I can replicate on the other 7 exhaust ports