Thanks for your comments Sieg. As I mentioned earlier over at Norwoods' thread I've found your project inspirational on more than one occasion.
In fact, it was between you and GW that I probably learned of HTP in the first place. Somehow I sort of overlooked the MIG200 you had purchased, or rather forgot about it when the INVERTIG 221 took center stage.
While I think TIG would be cool, and I am already fairly meticulous prepping for welds I just don't see myself doing enough fabrication to warrant the purchase... besides the technique there seems to be more metallurgy involved in selection of expendables, then there is the tungsten maintenance. I just don't need to take that leap and a MIG is the right choice for me.
What sort of setup table does your HTP MIG200 have? I am used to a nice chart inside the wire compartment on a Miller 252. Would you be willing to post a picture of yours at all please?
Also, how do you like the heat setting adjustment being what appears to be a 2 switch analog arrangement?
Thanks once again,
Robert
|