Quote:
Originally Posted by Sieg
Thanks for the input Rodger. Greg pointed out the company you're welding those for when we were cruising through Bakertuckey. 
That tungsten was violated just as I was finishing the weld. Typically I take it to a point with a little longer bevel than it appears in the photo. I did experiment with putting a slight flat on the point during the session, prefer pointed.
I completely agree with the heat control and it's much more involved than just setting your amperage. I'm going to start practicing/experimenting with pulsed mode/settings on thinner materials. I think that will compliment my lack of talent nicely. |
You should sand the tungsten before you take the pic. It makes you look like a pro. HAHAHA
Most of the time the pulse welding on thinner material is better done with the foot pedal. The pulse does not give you a real sense of heat control as more then likely you sheet metal fit on custom panels is not precise around the hole panel and since your margin of error is much tighter on sheetmetal. The pulse works great on thicker stuff that a robot can do as it is a machine fit constant gap. The foot pedal lets you control it much better for each individual weld bead.
For thinner stuff just cut some straight strips and weld them back together with out buckling the material from Heat. Then if you can weld it up and keep it flat and you turn it over and it is fully penetrated your golden.