Quote:
Originally Posted by GregWeld
WTF might as well make it a group buy!
|
I'll get the stock on order! Thanks Greg
Since it seems a lot of guys think billet parts are pretty cool, I shot a short video of the beginning of the finish pass. You can get a sense of why it takes so long to surface parts like this. The rapid speed is turned down, so the non-cutting time is a bit faster when turned up. Note, this is a 1mm (0.039") 3D step-over finish. Should be around 4 hours to get it surfaced.
Hope to have some more pictures of the finish pass on the outside later today.
