FWIW, I'm into my current headers for $187.10 (brand new including shipping) plus another $4.95 for some copper RTV sealant. I already had the sledge hammer to beat the tubes into submission, and I installed them myself.
I was just looking to see if any of the mid-price stuff might work with the mounts/x-member I already have. I could always see if a machine shop can mill the flanges to seal better on the heads, and ground clearance is fine.
__________________________________________________ __________________________________________________ ____________________________
This thread isn't about whether $900-1200 is too much for a nice set of stainless steel headers. It's about whether or not there is a cheaper alternative that fits.
|