Quote:
Originally Posted by rixtrix1
Always see neat stuff on which ever forum I see you posting. Nice to see you getting the frame table useable and back to work on the Chevelle. I need to find a ready source of cheap metal. Repurposing makes it a lot cheaper, and having the tools makes it easier, too. I'd say you have progressed very well in the years since you started posting. Thanks for sharing as always!
|
thanks for the interest in my projects and i 100% agree recycled is the way to go on so many levels you just have to be looking all the time Not just when you need it. stock pile the material until you get enough rounded up to complete the project. i think i have been side tracked enough in the last couple years now it is time to get back on the Chevelle again!
Quote:
Originally Posted by overlap
How does the bead roller make the panel recessed in the center without the outside edge being affected ? Is it the placement of the dies top to bottom or how they are machined ? Thanks
|
I could attempt to explain this but this would be better here is a link to a great metal shaper showing how this works. i hope this helps.
https://www.youtube.com/watch?v=Bw3_1dngly4
__________________
my name is Eric Hokenson I have a dream of building ten of the coolest hot rods out of my home shop wish me luck I am going to need it! - more pics on my web site
www.erodzcustoms.com this is just for fun and i am NOT looking for any more work!
Thank you supporting sponsors! without you guys there is no way I could do this myself !
Modern automotive performance,Ring bros.,Yank convertors,extreme drive systems,Cj tunes,race coatings stainless works,Modern Automotive Performance.all of these shops have the experience to get your car to the top.
