I'm finally getting around to assembling my sub frame, I know I need to use a 3/4x16 u joint, but I'm trying to figure out what the best route on this,
I see CPP make a Collapsible steering shaft that goes from the stock column to the rack,
http://www.ebay.com/itm/CPP-Collapsi...item41bba09f4d
Then there's Speedtechs version, which you get the adapter from factory column to the u joint to the rack,
http://www.speedtechperformance.com/...rod/prd417.htm
just picking some brains while I'm home assembling this,