Building a 9" Ford Rear - What Width?

[68ZClone]

What width rear end are most of you running in your cars? I'm modifying my 68 Camaro for street and some autocrossing. This will include the DSE mini-tubs. I've got most of the materials for a 9" Ford rearend and am curious if most of you are running stock width or narrowed. I know it ultimately depends on the wheel backspacing you want to run, wheel width, etc. But where are most of you starting out?

[will69camaro]

I believe 60 1/2" is stock width (axle stub to stub). I called DSE because I just bought a 9" off the used market that was a DSE unit asking what "typical" width was. They're all custom but I was told the common "narrow" axle is 2 7/8" on each side.

That's exactly what this one came out to, 54.75" width from stub to stub. I think he said with the minitub kit etc, it allows for 18x12" wheels and 4.75" backspacing.

Thats about the best I can do as far as explaining it. BTW this is all for 69 camaro so not sure how similar between the first gen years.

William

[68ZClone]

William

Thanks for the reply. That's exactly what I was looking for. We were discussing about 2" each side, so I know I'm in the ballpark. I've been hanging around the site for a while and learned a lot from you all.

[TheJDMan]

You really need to decide on your wheels first then narrow the rear to fit them.

[Firebird 68]

When you say stub to stub is that backing plate to backing plate? Any help would be great. Thanks

[TheJDMan]

Originally Posted by Firebird 68

When you say stub to stub is that backing plate to backing plate? Any help would be great. Thanks

Stub to stub is misleading. The correct way to measure is from wheel mount surface to wheel mount surface. That measurement needs to include any brake drum or rotor hat thickness. The 60.5" for the 1st gen Camaro is measured this way. But again, you need to know what your wheel backspace is in order to determine the axle width. Given the wheels I have I ended up with a 57" wide axle.