GM 12 Bolt Upgrade Q's

[Sonar Chief]

Hey, I'm NOOB when it comes to messing with rearends (cars ....) I would like to convert the GM Posi 3.55 12 bolt with a c-clip eliminator kit, anything else?

Can I use the same axles? IF I upgrade to larger spline axles then I need the posi unit also, right?

I would like to keep the 3.55's and if I could keep everything else that would be kool also .... cheaper too! I may participate in a auto-X or two but nothing like a circuit .... they are not here in NO Colorado, so street driven mainly!

Pro's and Cons with upgrading this 12 bolt?

Thanks for any advice ....

Michael

[Track Junky]

I've heard the c-clip eliminators eventually leak. I've been running c clips for as long as I've owned my car with no complaints. Only up grades have been the Eaton Posi and Moser axles.

[Sieg]

I stayed with the C-clip set up and went with Moser axles also.

If you're going to run rear discs the C-clip Eliminator kits are an issue and as Gaetano mentioned I've also heard they tend to leak.

How much power and power are you running?

[Sonar Chief]

Originally Posted by Track Junky

I've heard the c-clip eliminators eventually leak. I've been running c clips for as long as I've owned my car with no complaints. Only up grades have been the Eaton Posi and Moser axles.

That is good to hear .... did you upgrade to a larger spine axles w Moser? Hearing this I should be ok to run what I brung!

Originally Posted by Sieg

I stayed with the C-clip set up and went with Moser axles also.

If you're going to run rear discs the C-clip Eliminator kits are an issue and as Gaetano mentioned I've also heard they tend to leak.

How much power and power are you running?

Another concern ... I already have Wilwood on the axles now and don't really what to change. I definitely don't what to mess with leaks either.

I have a warmed over SBC 331 .... maybe 400hp if I'm lucky!

Thanks for chiming in guys I appreciate the comments!

[SlowProgress]

I took an old Mark Williams C-clip kit off when I upgraded to the 9-inch Ford ends for the Baer brakes. The bearing has an O-ring around the O.D. and then uses an outside sealed bearing. To make it all work you need to gasket or seal the backing plate to the axle housing and then the bearing cup needs to gasket or seal to the other side of the backing plate. Mine did weep a little on the right side enough to contaminate my brakes shoes. But I don't see why this would leak any more than any other sealed bearing if you take care !

I tried to take mine apart without a press and ended up damaging them. I should have just saved the axles complete for a rainy day !

[raustinss]

Moser axles...cheap click eliminator...upgraded posi and a rear gridle cover. Will take you into a 5-600 hp range safely. So do the mods and know that when you start adding power you may want make more mods to the rear end. Good luck