Corvette ZF 6 speed for LS conversion

[steinepstein]

Black label ZF 6 speed
QT bellhousing, new
McLeod hydraulic throwout bearing, new
2010 Camaro LS3 clutch, 1500 miles.
Fresh round of Amsoil synchromesh
Also have magnesium ZF bellhousing
$1900 obo plus the shipping
Located in Chicago

I'll consider trades for other manual transmissions...T56...If you want the whole setup..I'll let that go too..LY6 with custom harness.

I have this trans currently bolted up to a LS motor and have checked the clutch PP to throwout bearing distance, 5.5mm, all looks good..... I am still finishing the project but the car is a 62 Nova and the trans sits too low, I don't think it is going to work.

The LS conversion parts alone are over half the cost of this setup.

Also, I checked end play, spline meshing, and and shifting are all very nice on this trans.....but I cannot confirm mileage..


Thanks,

Jon

[Spiffav8]

Jon,

Per the forum rules you are required to list the location in the body of your add. Please edit it to reflect this.

Thank You

[NAPA 68]

He is in Chicago. I talked to him today.

Tim

[bret]

I'm interested in this. [email protected]. Thx!

[vstol]

Originally Posted by steinepstein

Black label ZF 6 speed
QT bellhousing, new
McLeod hydraulic throwout bearing, new
2010 Camaro LS3 clutch, 1500 miles.
Fresh round of Amsoil synchromesh
Also have magnesium ZF bellhousing
$1900 obo plus the shipping
Located in Chicago

I'll consider trades for other manual transmissions...T56...If you want the whole setup..I'll let that go too..LY6 with custom harness.

I have this trans currently bolted up to a LS motor and have checked the clutch PP to throwout bearing distance, 5.5mm, all looks good..... I am still finishing the project but the car is a 62 Nova and the trans sits too low, I don't think it is going to work.

The LS conversion parts alone are over half the cost of this setup.

Also, I checked end play, spline meshing, and and shifting are all very nice on this trans.....but I cannot confirm mileage..


Thanks,

Jon

Jon do you still have this?
Thanks Kevin

[steinepstein]

I kept it...got it to fit.

Thanks,

Jon

[vstol]

thanks