Parts for sale

[Teetoe_Jones]

I have the following items for sale in El Segundo, CA:

DSE close out panel- SOLD
Has been painted silver, does not have the fender braces and was never mounted


ACPT carbon drive shaft- $400 Sale Pending
Came from a late model 4th gen Camaro with a T56. Length, caps and yoke would be the same as a factory 4th gen driveshaft


Tilton dual master with 1st gen mounting plate- SOLD
Comes with masters, adjusting knob and firewall plate/clevis setup.



Stainless steel/mild steel bends- 20 bins of it- SOLD
This is all the materials I used to keep on hand to make the ATS Tri-Y headers in stainless and mild steel. This is valued at over $12K and it was all purchased from SPD. Jigs not included





ATS Tri-Y headers, mild steel with black Jet-Hot coating- Sold
Comes with V band collector clamps, never installed, never ran headers. Fits 1st gen Camaro, 3rd gen Nova



Anvil carbon rear spoiler, 67/8- SOLD
Came from my black 68 Camaro. Has clear coat chip on back side


2002 Z06 Corvette LS6 wiring harness- $75
Came off engine that was in an accident, battery acid got on some wires and melted them.


1968 Camaro RS vacuum hose, wiring, and misc parts- $300
All RS vacuum hoses, factory type wiring harnesses, new actuators, and parking light assemblies


Summit Racing brake prop/dist block- SOLD
Combo distribution block and brake bias knob


Champ Pans LSX oil pan-$200
Bare metal, no pick up tube, built to ATS specs



All items are less shipping.

Tyler