some eye candy

[TAC]

Heres a few pics of the spindle and upright assembly my friend made for his car. I used to work at a shop that did racecar fab so I helped him with the design and he did all the machining. They do a lot of Boeing and helicopter parts.
He is building a 71 datsun 240 . Although I still haven't convinced him to put a LS in it, it should be cool.

All the parts are custom including the spindle bearing nuts and the 12 point bolt. Even the knock off nut is custom.
The upright is ported for the cooling ducts to the rotor hub.
The rear ones are slightly different with cv shaft setup.
The tie rod connection is yet to be finished.