Fired up Engine...video

[G-Body]

Nice to fire up engine for the first time,
In car for mock up in these shots wanted to make sure ran and was tuned up before i scratched a nice new frame pulling it back out!

http://s229.photobucket.com/albums/e...rent=002-2.mp4

http://s229.photobucket.com/albums/e...rent=030-1.mp4

[zbugger]

Sounds good. And loud.

[Cole]

Right on. Nasty sounding

[intocarss]

That sounds good

[Shmoov69]

Dayum!!! Sounds angry!! What's inside it?!

[Track Junky]

Wow, that throttle is snappy!! Can we get some details?

[Flash68]

Oh yeah.

Bad ass machine.

[G-Body]

Sure thanks!

Its 406
11.6.1 Mahle forged flat tops
Scat crank and rods internally balanced
210 Pro Filers from Chad Speiers
2.08-1.60's 1.5 Harlands
Lunati Solid roller 243/249 @.050 595"
Hurricane intake ported by Chad to match
750 Mighty Demon flows 830 hvh 1"
Comp rev kit MSD billet dist.
CSR pump

Rossler T400 terminator
Neal chance 4,200
narrowed 9" with detroit locker
moser 4.56 gears
4 link on shock waves

Heres a video before i took the body off the frame to finish body work.
http://s229.photobucket.com/albums/e...rent=026-2.mp4



A few shots of the block...

[Track Junky]

HVH makes a great carb stacker. I tapped the back of mine with a 6an fitting for the power brakes and kinda of wish I would have taken a different route. I then had to take it off due to change in air cleaner but still have it.

Get a chance to dyno yet? Curious of rpm range.

[G-Body]

Haven't had it on dyno, on this tune up should make in the 560-580 range hp wise cam is good up to 7,200 shouldn't need more than 6,500- 6,800
Don't need to spin a 406 that high to make power.