Fuel Line Routing and Clamps

[lsuguy]

I am getting ready to route a custom 3/8" hard line on my 69 Camaro. I plan to run hardline within a couple feet of the fuel tank and fuel rail on my LS3.

How are you guys securing the fuel line to the floorpan of the car? I plan to use either billet line clamps or cushioned clamps but I am concerned about drilling holes into the floorpan. Maybe its a non-issue but just wanted to know what everyone was doing. Any pictures or advice would be greatly appreciated.

[DT69Cam]

I will be using the stock 3/8 line in SS. I cut both the front and rear of the line off and installed Swagelok fittings. Stock line=stock clips.

[Zspoiler]

I use "Adel" clamps to secure my fuel lines.

[randy]

i used stock fuel line clips since i used stock metal lines. Now underneath the car and on the area right before i would then run a flex line i used billet specialties fuel line clips.

[lsuguy]

Thanks for the feedback guys

[waynieZ]

I used the Swagelok fittings on mine too.

[Efi69Cam]

Those of you who use swageloks, did you tighten them per the instructions? I have not installed mine yet since the specs are for a thicker wall tubing than what the SS fuel lines are.

[DT69Cam]

Originally Posted by Efi69Cam

Those of you who use swageloks, did you tighten them per the instructions? I have not installed mine yet since the specs are for a thicker wall tubing than what the SS fuel lines are.

I went 1 Full turn + a 1/4.