69 camaro super charger ls6 t56 SKUNKWORKS

[frankv11]

Slowed down a bit , new member in the family
But still getting some work done
Brake lines are done was able to run one piece from proportioning valve to flex line for fronts. 3/16 SS. Any one looking to buy a flaring tool I will highly recommend the RIGID 458r for 45s and they also have a 37 degrees. That's the best tool I have bought and here benders same quality.
Fuel plumbing is also checked off the list 3/8 SS.
I ran both fuel and brake-lines on the inner side if rail "hope it don't get to hot"" maybe build a heat shield.

Rear end passenger side piece

Front passenger


Followed the DSE weld

[URL=http://s1232.photobucket.com/user/frankv11/media/Mobile%20Uploads/photo4_zps93ae9fe2.jpg.html]


Need just a bit if massaging here once I can get access to sett up clamps



Founds these at LBC swapmeet $50 ohh yeah

Cut rings to make them fit like I want them " tight"


Cut and flared out the buckets

Setting up clutch pedal with a stop and pushed pedal 1/4" towards passenger