Thermal arc 185- thoughts?

[racin66coupe]

been looking around at getting a compact TIG, went to a local store and they had one of these that theyve had for a while, brand new, said he would give it to me for 2k with a foot pedal and torch. i cant seem to find any reason to not buy this, as i havent seen any bad reviews on them yet..

[gerno]

I don't have that machine and don't have experience with a TIG at all but I do have a Thermal Arc Fabricator 251 MIG and really like the machine. It's very powerful but can be adjsuted down to work with thinner metal as well. I bought it used and have had zero issues with it besides the liner so I feel the quality is very good. Again, not specific to the machine you refer to but more in general for Thermal Arc... hope this helps.

STeve

[Sieg]

Compare it against the HTP Invertig 220. I ended up with the Invertig delivered at $2550 with extra consumables (rod) and 25' torch lead. Service and support has been above average.

[darrinf]

I've been looking at the Thermal Arc 181i, which does both Mig & Tig. It's priced around $800, add in gas, wire, etc and you're looking at around $1300 for the whole setup. It's not a heavy-duty welder by any means, but for light fabrication, sheet metal, even stainless exhaust, stuff like that it's probably just fine. It's a 180 amp machine so you can do up to 1/4". I also looked at the Miller Diversion 165 which is Tig only. It's priced a little higher but is probably a better machine. I guess it comes down to how much you want to spend and how much welding you're going to do.

[Revved]

I've got a Diversion 165 and I've been happy with it short of an intermittant glitch where it shuts off randomly as I hit the pedal. Just have to shut the machine off... turn it back on and its fine but too random to bother sending in.

Welding wise it does great once I got past my learning curve going from MIG to TIG. It's very basic and I do worry once I have to step up to a "real" TIG welder with all of the knobs and buttons

[IMPALA MAN]

I have a Thermal Arc 95S. Very compact. I am learning how to TIG and it doesn't seem too hard. I was really doing well but melting the tungsten. After reviewing the whole setup, I realized I had 75/25 mix Argon/CO2. I just got a 100% Argon tank and have not had a chance to try it yet. I know the welds I did with the mix were pretty good. I can only anticipate with the 100% Argon, it will only be better. So far, I would reccomend the machine without a doubt. $405.00 delivered to my door. (EBay). The only downside is, you cannot weld aluminum, but for $400.00 it's a great starter machine.