DSE roll bar with Ridetech door bar

[Golden_pilot]

I have a DSE roll bar installed and would like to put in door bars. I really like Ridetechs so I am wondering if anyone has tried installing them on the DSE roll bar?

[Sieg]

I believe the DSE hoop is 1-5/8" and Ride Tech's is 1-3/4". If you can get 1-5/8" clamps it could be done.

[Matt@BOS]

I have a DSE 4pt roll bar and used Tiger Cage clamps for the cross bar. Some modification may have been required, but I don't remember.

[Golden_pilot]

It looks like I could weld tabs in place of the clamps since the car is far from being finished. Though it might not look to good being two different size tubes. Thanks for the replies guys.

[Sieg]

Have you looked at Chassisworks door bar options?

[Golden_pilot]

Ya I had a look at them, I just preferred the look of Ridetech. But I can't download there catalogue at the moment since I'm in camp and the internet sucks. When I get home I will down load it to see if they have different styles then a straight bar.