Home electrical help (welder) - Lateral-g Forums

01somta · #1 02-02-2008, 09:26 AM

Calling all electricans, EE, people with 220 welders, or whoever wants to give their input. I just bought a lincoln 175 welder, It runs off of 220. Well here is my question the plug in the garage is 220/30amp, but the lincoln recommends that I have 40amp breaker. Is this just a "recommendation" from lincoln or is it manditory that I have a 40amp?

Beach Cruiser · #2 02-02-2008, 09:35 AM

The worst thing that can happen with an undersized breaker is that it will Trip more often if you over load it. If you find that it trips too frequently then you will need to upgrade to the 40 amp, but you will also need to upgrade the wiring to handle the additional load. If you are just doing light fabrication work and not really taxing the system, the 30 amp breaker should be fine.

awr68 · #3 02-02-2008, 12:32 PM

I thought the 30 and 40 amp plugs are differant....Will your welder even plug into the existing outlet?

Where's Mike?!

01somta · #4 02-02-2008, 03:54 PM

Quote:

Originally Posted by awr68

I thought the 30 and 40 amp plugs are differant....Will your welder even plug into the existing outlet?

Where's Mike?!

yes they are different, but I made a 10ft ext cord with a 10ga. wire with the correct female plug for the welder and the correct male plug for the wall.

**Bill Howell** · #5 02-02-2008, 08:46 PM

The problem is the wire from the panel to the plug. I am sure if it was wired for a 30 amp, then the wire was sized accordingly. Be sure to check and see what wire was used before you just switch the breaker. If in fact, proper wire was used (and this will depend on distance from panel to plug as well), then just change the breaker. If not, I suggest you run proper wire and make a new circuit.

Bodies67 · #6 02-03-2008, 01:36 PM

I'm a electrical contractor in louisiana. If you have a 30 amp plugin in your wall you should have a # 10 wire for it. If you need a 40 amp plugin on your welder you need a #8 wire to carry that.If you just change the end the welder could pull more amp's than the wire is rated for and either melt the end of the plug or melt the wire in the wall and cause a fire.If you are not going to use it alot you might be OK.But any new or remodel we do and they want a welder plug . We run #6. It 's good for 60 amps. We always over kill but we don't have fires. Hope this was helpful.