HELP ID'ing HOSE CLAMP!!! (not gates power grip) - Lateral-g Forums

64pontiac · #1 01-11-2010, 08:33 PM

Ok.... so take a look at Mark's Jackass intake tube ( 4 inch diameter I believe) and help me find out what kind of clamps he used?!?!?! They are super clean black clamps, and unless the joint/bolt etc is hidden underneath, they look completely smooth......

the gates clamps are wider and dont go that big... soI have no clue. BDL inustries has a nice clamp but they have visible fasteners and hinge points...

any thoughts?

Vegas69 · #2 01-11-2010, 08:53 PM

**GregWeld** · #3 01-11-2010, 09:34 PM

It's a lot easier just to ask him yourself... I'm sure he'd know what they are.

You can PM people... do you know how this is done?

deuce_454 · #4 01-11-2010, 10:35 PM

are you talking about "Gates PowerGrip®" Hose Clamps ?

from 1/2 to 3-5/8 diameters... (no 4 inch though)
http://www.jegs.com/p/Gates/Gates-Po...43359/10002/-1

Bow Tie 67 · #5 01-12-2010, 05:53 AM

He used hose clamps with black heat shrink.

Northeast Rod Run · #6 01-12-2010, 10:10 AM

Quote:

Originally Posted by Bow Tie 67

He used hose clamps with black heat shrink.

I use heat shrink on some things. it's super cheap (but doesn't look it) and it cleans up things a little bit. an ISCA judge told me about that trick before