Looks like one header tube will be in the way. Considering using 3 U-joints with a bracket attached to the subframe. Not sure if this is possible/feasible. I'm running wayne due subframe with LSx motor. Dougs LSx headers. I have everything fitting good now but this is my next obstacle. Using adj motor plates, and motor is in the all the way back position. If anyone has pics of their setup, shoot them to me at [email protected].
Scott
In your situation would it be more difficult to modify a header tube or two to allow a 2 joint shaft? Unless the headers are coated, I have always tried this route if at all possible before running a 3 joint shaft.
They are coated. It is only one tube that is in the way. I would actually consider buying a different set of headers if I knew for sure they would clear the shaft. I could re-sell mine to offset the cost. I do know of a shop that could alter the headers, but not sure of the cost or what to do about re-coatong the area. Scott
Brian Hobaugh SCCA National Tour June 2014
First Hemi 'Cuda Convertible Ever Built
Short clips: Goodguys Pleasanton autocross and pit videos
Anyone use 3 steering shaft joints?
Hybrid Mode
