Really need some help

[redsand]

Been getting different answers and need to confirm with the team here that have run the following to 100 percent confirm

69 camaro
Dse mini tub
Ride tech 4 link
Has anyone successfully run a 335 tire with an 18x12 wheel without rubbing.
Some searches I have found where Bret said yes, they have run a 335 and had some answers saying the g r/s givaway car had them but there was some rubbing

I just need a 100 percent confirmation if anyone is running the setup with a mosier 12 bolt stock length

Also what backspacing did you run in the rear??

Any help would be extremely appreciated

[64pontiac]

Someone else can weigh in, but its all in the backspacing. 69 Camaro and minitubs fits a 12 wide with 335s no problem, you just have to nail the backspace for your diff width. We do it lots but with Speedtech rear torque arm.

As long as your rear suspension is centered and you measure twice for backspace, you'll be fine. You might have to trim back or fold up the edge of the quarter lip depending on your chosen ride height but thats it. Heck we can even pull our 19x12s on one of our camaro installs without dropping the coilovers and the diff down, just because of its ride height.

[redsand]

I have plenty of wheel tub.... My problem is that the 335 when mounted in the wheel well seems to hitting the bottom bar of the 4 link or is very very close and being told might rub

[dhutton]

Do you have the offset lower bars?

Don

[LS7 Z/28]

If it's in the way, move it. I would add a 1/4 or 1/2" wheel spacer to each side and clearance the quarter panel lip of the wheel opening if you are concerned about it. I'm assuming you don't want to modify the suspension. I think that will be the easiest route to achieve what you're after.

[Musclerodz]

you need the offset lower bars if you don't have them. otherwise it should clear fine.

[bret]

Originally Posted by redsand

Been getting different answers and need to confirm with the team here that have run the following to 100 percent confirm

69 camaro
Dse mini tub
Ride tech 4 link
Has anyone successfully run a 335 tire with an 18x12 wheel without rubbing.
Some searches I have found where Bret said yes, they have run a 335 and had some answers saying the g r/s givaway car had them but there was some rubbing

I just need a 100 percent confirmation if anyone is running the setup with a mosier 12 bolt stock length

Also what backspacing did you run in the rear??

Any help would be extremely appreciated

I'd like to see the posts that refer to rubbing issues on the Goodguys Camaro. . I built that car. Nothing rubs. Anywhere. Ever.

[redsand]

Bret IM me when you get a chance.... I have a feeling that there is some confusion between the givaway car and the 48 hour camaro but not sure

I am starting to think it is the tire..... It is a BFG kdw 2 amd appears to be measuring more than a 335. If we stuff it in the wheel well even with the dse mini tubs there is very little room if any....at this point we are going to roll the qtr lips and move the mounts inboard a bit for clearence.

[71RS/SS396]

Something is not right. My wifes 69 with DSE tubs and has plenty of room with 335 Rivals which are wider than KDWs, the lips are not rolled either. Does the tire fit without the 4 link bars bolted on?

[redsand]

It does but it is very very tight