Brake line size?

[jlwdvm]

I am getting ready to order some Copper Nickel brake line to bend up for my 69 Firebird track car. Stock lines were 3/16" to each front corner and on the rear end for the rear corners. The long run from the master to the rear was 1/4". Should I stick with these sizes for my manual 6/4 piston Willwod setup. or would all 3/16" be fine?

[youthpastor]

Originally Posted by jlwdvm

I am getting ready to order some Copper Nickel brake line to bend up for my 69 Firebird track car. Stock lines were 3/16" to each front corner and on the rear end for the rear corners. The long run from the master to the rear was 1/4". Should I stick with these sizes for my manual 6/4 piston Willwod setup. or would all 3/16" be fine?

All 3/16 the old 1/4 was for drum brakes.

[jlwdvm]

Thanks. I seen that Mark S used all 3/16" on the Mule...according to his build book.

[Stielow]

Originally Posted by jlwdvm

Thanks. I seen that Mark S used all 3/16" on the Mule...according to his build book.

If you do ABS do 1/4 to the ABS module then 3/16 to the corners.

Mark

[jlwdvm]

ABS?....that's a good one!!!

[Vega$69]

I just finished my build and use all 3/16 copper nickel lines. Corvette C6 ZO6 Brakes with a Wilwood MC and Prop valve no booster.

Car stops great