manifold conversion?

[67ragtp]

Im looking for someone that does quality work to convert my merlin single plane intake to fuel injection, anyone have a guy that they think is good? Any one other than holley making a single plane intake already set up with FI bungs and rail supports?

Thanks Rich

[camcojb]

Originally Posted by 67ragtp

Im looking for someone that does quality work to convert my merlin single plane intake to fuel injection, anyone have a guy that they think is good? Any one other than holley making a single plane intake already set up with FI bungs and rail supports?

Thanks Rich

Edelbrock also makes EFI-ready manifolds. http://www.force-efi.com/ can modify your manifold.

Jody

[JamesD]

This is the guy I plan on using:

http://www.hotrodsolutions.net/IntakesEFI.html

[nitrorocket]

Do you have a tig welder? It is pretty simple!

Basically you just lay out the center of the port, have a machine shop punch the holes, weld in the bungs, and punch holes on the same centers in the flat side of your fuel rail stock.


Otherwise start surfing around online.

[67ragtp]

I dont have a Tig welder only Mig. Thanks for the suggestions, edelbrock sells the EFI victor junior, I hope the manifold performs as well as my single plane Merlin. The conversion will probably cost me more than buying the new manifold with rails at $377.00. Not to many options with efi single plane manifolds.

Rich

[nitrorocket]

From what I have heard, the edelbrock Victor Jr. will perform better then the Merlin. Would be nice to pick up a little power with the Edelbrock, because fuel injection will not give any more peak power.