Anyone run plug wires underneath headers on a BBC?

[BThibodeaux]

I want my engine compartment to look as clean as possible, so I plan to run the plug wires underneath the headers on my BBC build. Has anyone done this? If so, can you share some pics and give me some pointers? Thanks.

[HRBS]

Run them underneath from behind and use wire seperators. By using 8.5 wires the combonation of "stiffness" and seperators will hold them in place under the tubes. It also depends on what type of header you use. The orange car had full tube headers and the green car had block huggers. It is nearly impossible to do with the block huggers because of the tube configuration.
Note the difference here:

Tucked under and hidden:


Run down the side of the valve cover but on top of the headers:

[BThibodeaux]

[QUOTE=HRBS]Run them underneath from behind and use wire seperators. By using 8.5 wires the combonation of "stiffness" and seperators will hold them in place under the tubes. It also depends on what type of header you use. The orange car had full tube headers and the green car had block huggers. It is nearly impossible to do with the block huggers because of the tube configuration.


Thanks Steve, both look great! I will be running mid length headers. Hopefully I will have the room to run them underneath.

[Fotoboy]

[ProTouring442]

Sweet! I'm guessing you purchased a "terminate your own" kit, or does someone make them like that?

Shiny Side Up!
Bill
'72 442 "Inamorata"
www.FQuick.com/ProTouring442

[HRBS]

Absolutely.... otherwise you'd never be able to snake them around that long of a distance.