JCG Restoration & Customs 69 build - Page 6 - Lateral-g Forums

bentfab · #51 09-30-2009, 10:00 PM

Quote:

Originally Posted by Steve1968LS2

You're hired!

The car will be in a week or two..

Mine would run down (no AC compressor) and under the core support to the intercooler. Should be simpler.

Very nice work.. as usual

Cool !! Thanks

It will probably be closer to the three week or too !! I have another 69 waiting in the shop for a full plumb jod as well. He's my number one priority cause he let me slip J.C.G.'s 69 in for the S.E.M.A crunch. Give me a buzz or stop on buy.

nvr2fst · #52 09-30-2009, 10:45 PM

Quote:

Originally Posted by bentfab

Steve 'O

Check out these pics!!!!

You definitely have some killer skills and design thoughts when commencing on the projects sent to you. Keep up the great work!

**tones2SS** · #53 10-01-2009, 08:42 AM

Very nice. Keep up the good work.

Cris@JCG · #54 10-05-2009, 06:45 PM

Here are some pics of what we did to get some clearance under the hood for the supercharger! We cut out the center section to gain as much clearance as we could & then cut up a doner hood to add a second layer on the inside of the cowl hood for strength & used panel adhesive! Alot of work when we could have just ordered a hood from Anvil that would have given us the same clearance but the customer did not want a fiberglass hood!!!

Al Moreno · #55 10-05-2009, 09:14 PM

That's going to look awesome! Keep the pics coming.

Did I read somewhere that this car is going to be at SEMA?

Cris@JCG · #56 10-06-2009, 08:33 PM

We should be done with the hood 2morrow!! ordering Anvil cowl vents to finish it off!

This build was selected to be @ HRIA booth but unfortantly we will not have it done.. I dont even have paint on the car yet!

Quote:

Originally Posted by Al Moreno

That's going to look awesome! Keep the pics coming.

Did I read somewhere that this car is going to be at SEMA?

Damn True · #57 10-07-2009, 08:27 AM

Quote:

Originally Posted by Gonzo

Just got back from Bent Custom & Performance!! Mark sure can plumb a car! While the car was their I had him do the exhaust for the car.. Off to a good start on the exhaust.. Also included some pics of the steering column collets, cage nut covers, & coil pack brackets we machined..

Boy, is that master cyl. install clean or what?

bentfab · #58 10-09-2009, 01:12 PM

Here's a couple more shots. Finished exhaust and some plumbing pics. Car's back in J.C.G.'s hands. Thanks again Cris.

What do you guys think of the hangers?

**tones2SS** · #59 10-09-2009, 03:22 PM

Very nice.
Those exhaust hangers are pretty trick!

**waynieZ** · #60 10-09-2009, 05:42 PM

Awesome job on the exhaust those hangers are sweet. Nice plunbing too . Whos fittings did you use?