CNC Table for plasma cutter..

01-17-2006, 09:11 AM

PaceCarNut PaceCarNut is offline

Supporting Member

Join Date: Aug 2005

Location: on the Right Side of the country

Posts: 53

Thanks: 0

Thanked 0 Times in 0 Posts

CNC Table for plasma cutter..

Anyone using one of these or something similar? Im am looking at buying this set-up here from torchmate. http://torchmate.com/overview/torchmate2.htm I will make my own stand and water tank for below. I am at the point it would be nice to not have to and cut everything plus if the patteren could be saved on a laptop then all brakets would always come out the same. Any opinions on this setup? Thanks, Chuck

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -7. The time now is 10:21 PM.